Thread: Re: extruded-aluminum frame as small parts
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:15
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
if smaller than 2X3 no need...
Posted by Joe Johnson at 1/19/2001 10:50 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: Re: extruded-aluminum frame as small parts
Posted by Ken Leung on 1/19/2001 9:39 PM EST:



If your extrusions are smaller that 2" X 3" you need
not account for them at all, nor buy them from Small Parts.

Extrusions are on the additional material list --
unlimited!

My interpretation is that unlimited means unlimited
(but 130 lbs is still 130 lbs!)

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.