Thread: Re: extruded-aluminum frame as small parts
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:15
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: extruded-aluminum frame as small parts
Posted by Jason Rudolph at 1/19/2001 6:47 PM EST


Other on team #459, Rampage, from University of Florida/Eastside High School and .


In Reply to: Re: extruded-aluminum frame as small parts
Posted by CArobot on 1/19/2001 6:24 PM EST:



Well, as long as the cross-section of the aluminum you are using is 2inches x 3inches, then you can count the items as from the additional hardware list, even though you bought them from small parts. If the cross section is larger, then you have to count it from small parts. Yes, you can get it from other manufacturers (i.e 80/20), but the cross section MUST be 2inches x 3inches or less.

Jason
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.