Thread: 5/16" cold steel shafts...
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 23:17
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
that is the current plan...except for the shaft to the motor
Posted by Anton Abaya at 1/20/2001 2:31 AM EST


Coach on team #419, Rambots, from UMass Boston / BC High and NONE AT THE MOMENT! .


In Reply to: Re: 5/16" cold steel shafts...
Posted by Ken Leung on 1/20/2001 1:04 AM EST:



aye...i agree with ya.

the only shafts we'll have i expect are the ones connected straight to the motor from which sprockets will drive the wheel sprockets via a chain system.

do you really think they'll bend? hmmm.... lemme think of a solution then. we wanted a rather open wheelbase...like a car or something.

-anton
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.