Thread: Next Question - Check Valve
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:18
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Next Question - Check Valve
Posted by Jason Rudolph at 1/20/2001 3:21 PM EST


Other on team #459, Rampage, from University of Florida/Eastside High School and .


In Reply to: Next Question - Check Valve
Posted by Josh on 1/20/2001 12:33 PM EST:



What you might want to do, is if you are not planning on using the pilot controlled check valve, then you can put that on the input of the air tanks, and put the plug valve on the other side of the pilot valve. Then, use the plug valve to relieve all the pressure in the line, and the pilot valve will keep all the air in the tanks, then just remove everything except the pilot valve, and you should be good to go.

Jason
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.