Thread: Next Question - Check Valve
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:18
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Next Question - Check Valve
Posted by JVN at 1/21/2001 1:02 AM EST


Student on team #250, GE Dynamos - Capital District Robotics Team, from Shenendehowa High School and General Electric.


In Reply to: Next Question - Check Valve
Posted by Josh on 1/20/2001 12:33 PM EST:



Josh-

we've been having trouble with the check valves too. They stick sometimes and leave both sides
open. We loosened em up by putting a higher PSI though them and just working em. If that
doesn't work, maybe you should try a large hammer?

You'd think they'd get the p-new-matics right after all this time.

~John #250 (still pissed because we don't have a vacuum generator this year)


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.