View Single Post
  #8   Spotlight this post!  
Unread 23-06-2002, 23:23
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Changing Gears

Posted by ChrisH at 1/23/2001 1:48 PM EST


Engineer on team #330, Beach 'Bots, from Hope Chapel Academy and NASA JPL, J & F Machine, Raytheon, et al.


In Reply to: Re: Joe's post
Posted by Justin Stiltner on 1/22/2001 1:24 PM EST:



We did it a few years ago. It involved disassembling the worm section of the motor and changing the output shaft. Since the worm section is crimped together it was difficult and fortunately we only needed one motor because we screwed up the first one.

It was also one of the reasons for our policy of off the shelf motors only! (See earlier posts)

Chris Husmann, PE
TEam 330 the Beach 'Bots


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.