Thread: wheel hub kit and sprocket
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:26
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
they are supposed to
Posted by Ken Leung at 1/22/2001 5:34 PM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: wheel hub kit and sprocket
Posted by james on 1/22/2001 4:14 PM EST:



: the wheel hub kit and sprocket from small parts do not fit right off the shelf. are we supposed to mill the bore to fit? the diagrams don't indicate that this needs to be done. please help anyone??

: thanks

Our team receive those wheel hub and they fit right into the wheelchair wheels perfectly... since the hubs are supposed to have one size, I believe your problem might be caused by defection. You should order some more wheels to see if that's the problem, and you should have spare wheels anyway. And no, we didn't need to mill the bore to fit... unless the hubs are defected. The best thing to do right now is the do precise measurment on the hubs AND the wheels and compare them to the diagrams... and ask Small Parts if you need clarification on the diagram, or post on this forum.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.