Thread: wheel hub kit and sprocket
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:26
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: they are supposed to
Posted by james at 1/22/2001 6:26 PM EST


Coach on team #694, PULSE, from stuyvesant high school and AOL Time Warner.


In Reply to: they are supposed to
Posted by Ken Leung on 1/22/2001 5:34 PM EST:



asked the wrong question i guess. the sprocket doesn't fit the way it's diagrammed. the wheel hub fits, but according to the diagram, the sprocket then goes on after that. the sprockets bore sizes are 3/8, 1/2 etc, but the diagram shows it fitting on the wheel which is around 1". to fit a sprocket on the hub, do we have to mill the sprocket?

thanks for answering.

james ng
p.s...where are you guys from?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.