[samir13k]

no offense taken...
Anyways, if you look at FirstBase by autodesk, it says that the drawings will be released around kickoff (from what i can remember). Unforunately, NI's drawings from their website are in IGES form, and you will run into problems with opening them on autodesk. Obviusly, First Cad Library is usually the most reliable source, but they can only make the models after they recieve the parts. This unfortunately means that there are not many usable models out yet. That is why i made my model. It is fairly accurate, so if you want to plug it into an old robots drawings, then it will serve its purpose to show the general area taken up.

Long story short, models will be released eventually, but most are not available yet. Im sure First Cad Library will start theirs asap, but making models is a fairly long process when you reach the precision of them.

Hope that makes sense.