Thread: Need Help on Shaft Mounting...
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Need Help on Shaft Mounting...
Posted by Anton Abaya at 1/23/2001 2:08 AM EST


Coach on team #419, Rambots, from UMass Boston / BC High and NONE AT THE MOMENT! .



Assuming we wanted to mount some fixed shafts for wheels to spin on, what have you guys done in the past?

Last year we had mounts that were unberaably difficult to disassemble when it was needed and so it brought more problems than expected.

Say we wanted to mount the shaft on both sides (it's supported by two mounts), what would you guys recommend for easy disassembly and easy installation? The less machining the better.

-anton
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.