Thread: Need Help on Shaft Mounting...
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
My favorite method.
Posted by Matt Berube at 1/23/2001 8:09 AM EST


Engineer on team #49, Delphi Knights, from Buena Vista High School and Delphi Automotive.


In Reply to: Need Help on Shaft Mounting...
Posted by Anton Abaya on 1/23/2001 2:08 AM EST:



My personal favorite method is to construct two ridgid mounts, drill STRAIGHT though the both of them, and use one of those nifty ground shoulder bolts. You can then put your bearings inside of the wheel and mount your sprocket/gear to the side of the wheel to make it turn.

Matt B.
T49
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.