Thread: Loss of signal in PWM cables.
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Loss of signal in PWM cables.
Posted by Michael at 1/23/2001 10:36 AM EST


Other on team #271 from Bay Shore High School and Verizon.



Hey y'all . . .
This is my first post to this forum, but I've got a question that I haven't really been able to find an answer for.

Has anyone suffered any problems with their PWM cables with respect to signal loss? We've (We being team #271) got to run a PWM cable to a servo at the end of a long arm, and we'll need some ridiculous amount of cable. . .something like 12'. Being that the wire is so small in diameter, I was worried about internal resistance and all, and wondering if the signal would get that far.

Any advice?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.