Thread: Loss of signal in PWM cables.
View Single Post
  #6   Spotlight this post!  
Unread 23-06-2002, 23:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Loss of signal in PWM cables.
Posted by Michael at 1/23/2001 2:22 PM EST


Other on team #271, Mechanical Marauders, from Bay Shore High School and Verizon.


In Reply to: Re: Loss of signal in PWM cables.
Posted by Justin Stiltner on 1/23/2001 12:05 PM EST:



Thanks for the quick responses!

I hadn't even considered splicing in a larger wire. I'm not an electrical genius, if you couldn't tell. I like pulleys and other mechanical things that I can see working.

Anyway, thanks again for the help.

- Michael, off to formulate a new plan, just in case we do lose the signal.





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.