Thread: Sharp Wheels
View Single Post
  #18   Spotlight this post!  
Unread 23-06-2002, 23:30
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Be sure to Deburr
Posted by Jason Iannuzzi at 1/24/2001 10:05 AM EST


Engineer on team #11, Marauders, from Mt. Olive HS. and BASF, Rame Hart, CCM.


In Reply to: Sharp Wheels
Posted by Josh Vetter on 1/23/2001 12:04 PM EST:



I think almost any wheel type would be OK, just make sure you have removed the sharp edges. If you use a gear, try running all the teeth through a wire wheel first, it will remove the burrs and significantly reduce carpet destruction.




__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.