View Single Post
  #25   Spotlight this post!  
Unread 23-11-2008, 22:12
CraigHickman
 
Posts: n/a
Re: pic: Mecanum Musings

Quote:
Originally Posted by Brandon Holley View Post
I've spent some time designing mecanums (on a smaller scale), and I have my own method, but I was wondering if you would share the method you used to create the curvature of the roller. Specifically in CAD terms (I'm very familiar with any CAD system), what you did to ensure your roller curve was as effective as possible.

Thanks in advance!
Brando
Sure thing. Start with a center line that will serve as an axis to revolve the roller around. Next, draw your edge lines on the left and right edges of the axis. Put a third in the center, higher than the first two. Draw two arcs connecting these outer lines to the center line. Let me know if this is confusing and I can upload a drawing for you.

Quote:
Originally Posted by Hell918 View Post
The only question i would ask would be if they were to be bumped into would they break easier or would they still have enough strength.
They're quite solid as they stand, but I don't like leaving a wheel uncovered for any reason. For that reason I'll probably enclose the wheels, most likely in 1/8th aluminum sheet on which the bumpers will be mounted.
Reply With Quote