|
Re: pic: Mecanum Musings
Quote:
Originally Posted by Speedfiend
Sure thing. Start with a center line that will serve as an axis to revolve the roller around. Next, draw your edge lines on the left and right edges of the axis. Put a third in the center, higher than the first two. Draw two arcs connecting these outer lines to the center line. Let me know if this is confusing and I can upload a drawing for you.
|
I believe I understand what you are saying, it is similar to what I do as well, but a picture would not hurt... thanks!
__________________
MORT (Team 11) '01-'05 :
-2005 New Jersey Regional Chairman's Award Winners
-2013 MORT Hall of Fame Inductee
NUTRONs (Team 125) '05-???
2007 Boston Regional Winners
2008 & 2009 Boston Regional Driving Tomorrow's Technology Award
2010 Boston Regional Creativity Award
2011 Bayou Regional Finalists, Innovation in Control Award, Boston Regional Finalists, Industrial Design Award
2012 New York City Regional Winners, Boston Regional Finalists, IRI Mentor of the Year
2013 Orlando Regional Finalists, Industrial Design Award, Boston Regional Winners, Pine Tree Regional Finalists
2014 Rhode Island District Winners, Excellence in Engineering Award, Northeastern University District Winners, Industrial Design Award, Pine Tree District Chairman's Award, Pine Tree District Winners
2015 South Florida Regional Chairman's Award, NU District Winners, NEDCMP Industrial Design Award, Hopper Division Finalists, Hopper/Newton Gracious Professionalism Award
|