Thread: dimensions of horizontal bar
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:31
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: dimensions of horizontal bar
Posted by Mike Sklar at 1/23/2001 8:45 PM EST


Engineer on team #21, ComBBAT , from Astronaut H.S. and Titusville H.S. and Brevard Community College and Boeing Company and NASA-KSC.


In Reply to: dimensions of horizontal bar
Posted by Travis Covington on 1/23/2001 8:03 PM EST:



:The distance from the plywood base to the center of the horiz pipe is defined by the kee clamp fittings. If you have that you can figure it out. If we get a chance we'll measure it and post it here.

The distance from the outside edge of the plywood base to the center of the horiz pipe is another matter? This is a "Yet Another Undefined" (pronounced Ya Hoo) dimension of the now infamous field drawing. We wonder the samething and wish someone from the FIRST staff would post the dimension here or in an update! HINT HINT!
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.