Thread: dimensions of horizontal bar
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 23:31
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: dimensions of horizontal bar
Posted by Stephen Riley at 1/24/2001 8:48 PM EST


Engineer on team #419, RAMBOTS, from Wentworth Institute of Technology and Umass/BCHigh and Mathsoft, Solidworks, and NASA.


In Reply to: dimensions of horizontal bar
Posted by Travis Covington on 1/23/2001 8:03 PM EST:



: what is the distance from the top of the plywood base of the goal to the center of the horizontal 1 1/4 in. aluminum pipe. Also what is the distance from the center of the same pipe to the edge of the base of the goal.

the distance from the top of the plywood to the middle of the aluminum pipe is 2.5" not as my teammate said it (i guess hes a bigger ninny than me), i hope that helps you, cause i know that when i was doing the goal math it was a real pain in the $@#$@#$@# where one thing contradicts another, gotta love how they do that on the designs
Steve
AKA BallBoy
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.