Thread: dimensions of horizontal bar
View Single Post
  #7   Spotlight this post!  
Unread 23-06-2002, 23:31
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: dimensions of horizontal bar
Posted by Stephen Riley at 1/25/2001 10:18 PM EST


Engineer on team #419, RAMBOTS, from Wentworth Institute of Technology and Umass/BCHigh and Mathsoft, Solidworks, and NASA.


In Reply to: Re: dimensions of horizontal bar
Posted by Travis Covington on 1/24/2001 9:01 PM EST:



:
: how about the distance to the bar horizontally from the edge of the plywood?

that is a very good question, and one i still working on, since i can't find any measurments at all for it anywhere, right now i made an edumacated guess at it ( i eyeballed it on the placement on the mockup) it may wok, i hope it does, i wasn't yelled at for it at least


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.