Thread: Screws, Nuts and Bolts....
View Single Post
  #7   Spotlight this post!  
Unread 23-06-2002, 23:32
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: what about a screw meant as a shaft?
Posted by Matt Leese at 1/24/2001 9:16 AM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Rochester Institute of Technology.


In Reply to: what about a screw meant as a shaft?
Posted by Anton Abaya on 1/23/2001 11:09 PM EST:



According to FIRST it only counts as a fasterner if ALL it's doing is fastening. It can be structural support, etc.

Matt who still enjoys the fact that velcro was consider a fastener when it was used to pickup floppies....
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.