Thread: Screws, Nuts and Bolts....
View Single Post
  #8   Spotlight this post!  
Unread 23-06-2002, 23:32
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Are you sure?
Posted by Nate Smith at 1/24/2001 10:49 AM EST


Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.


In Reply to: Re: what about a screw meant as a shaft?
Posted by Matt Leese on 1/24/2001 9:16 AM EST:



: According to FIRST it only counts as a fasterner if ALL it's doing is fastening. It can be structural support, etc.

I know that last year, the original AHL specifically said fasteners could be used for fastening only. But, at some point during the season, they removed this restriction. I don't see any sort of restriction saying that fasteners can only be used for fastening this year, i.e. they would be able to be used as a pivot point, etc. I could just be overlooking something in the rules, so don't quote me on this just yet...

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.