Thread: Control System Mounts?
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:33
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Control System Mounts?
Posted by Justin Stiltner at 1/24/2001 12:54 PM EST


Student on team #388, Epsilon, from Grundy High School and NASA, American Electric Power, Town of Grundy.


In Reply to: Re: Control System Mounts?
Posted by Matt Berube on 1/24/2001 8:48 AM EST:



: You may want to consider velcro for holding down the speed controllers. It has worked well for us.

: Matt B.
: T49

I see no problem with mounting it straght on an AL plate....... if you use good wireing habits and use the wire tie bases you souldent have any problems. and I see no use for electrical insulation between the bot and the controll system..... the case is plastic

Justin Stiltner
Team #388
Grundy Va,



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.