Thread: Control System Mounts?
View Single Post
  #12   Spotlight this post!  
Unread 23-06-2002, 23:33
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Control System Mounts?
Posted by Tom S. at 1/24/2001 8:19 PM EST


Student on team #177, The Bobcats, from South Windsor High School and International Fuel Cells & ONSI.


In Reply to: Control System Mounts?
Posted by Anton Abaya on 1/23/2001 11:15 PM EST:



here is a pic of ours...

Basically it is just the components mounted on polycarb.. Speed controllers all in a line, three spikes in a line, everything is bolted to the control board with a polycarb cover protecting it from the outside.

Tom

: I recall seeing different varieties of this... Wood, Lexan, Plexiglass (2 years ago), and various other concoctions...

: any others i may have missed? wanna share some good advice for conserving space and preserving beauty? or is lexan the best for the job?

: *note that i am referring to the robot controller mount.

: ** but if u have ideas for operator interface mounts, post that too.. i saw some cool ones last year that i never took pictures of...

: as always, thanks
: -anton






__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.