|
Re: pic: Madtown Robotics Drive Proto
Quote:
Originally Posted by rc_cola1323
The gears are all steel, but they have been faced down (from a 3/8 to a 3/16) and they have holes drilled into them by using an index. The weight is accurate but it does not include motors. BTW, there are only five gears (exclude cim gears) in this assembly and we have found a sponsor that will anodize the gears for us.
|
What grade steel were you planning on using? Did you feel that this grade was not going to be strong enough? I was under the assumption that its not possible to anodize steel.
__________________
MORT (Team 11) '01-'05 :
-2005 New Jersey Regional Chairman's Award Winners
-2013 MORT Hall of Fame Inductee
NUTRONs (Team 125) '05-???
2007 Boston Regional Winners
2008 & 2009 Boston Regional Driving Tomorrow's Technology Award
2010 Boston Regional Creativity Award
2011 Bayou Regional Finalists, Innovation in Control Award, Boston Regional Finalists, Industrial Design Award
2012 New York City Regional Winners, Boston Regional Finalists, IRI Mentor of the Year
2013 Orlando Regional Finalists, Industrial Design Award, Boston Regional Winners, Pine Tree Regional Finalists
2014 Rhode Island District Winners, Excellence in Engineering Award, Northeastern University District Winners, Industrial Design Award, Pine Tree District Chairman's Award, Pine Tree District Winners
2015 South Florida Regional Chairman's Award, NU District Winners, NEDCMP Industrial Design Award, Hopper Division Finalists, Hopper/Newton Gracious Professionalism Award
|