Thread: Dismantle Solenoid valve?
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:34
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: nope, sorry
Posted by Josh Vetter at 1/24/2001 11:15 PM EST


Student on team #548, Robostangs, from Northville High School and BOSCH.


In Reply to: nope, sorry
Posted by Jason Rudolph on 1/24/2001 6:38 PM EST:



Not the answer I was hoping for, but thanks anyways.
Josh

: Well, I'd have to say no. Rule M15 in the manual says that "pneumatic components in the kit may not be modified except as follows:" and after that, it does NOT say you may modify the solenoids. The only exception being that you can modify the wiring so that it will interface with the control system.
: Hope this helps,

: Jason


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.