View Single Post
  #8   Spotlight this post!  
Unread 01-12-2008, 22:53
CraigHickman
 
Posts: n/a
Re: pic: Bane Bots Gearbox CAD

Quote:
Originally Posted by roboticWanderor View Post
This is not that heavy of a reduction, just 24:1. the only thing i am really worried about is the mount of the actual motor, I had to bore into the delrin a bit to get the motor pinion far enough out the other side, making the material that holds in the motor is 1/8 thick instead of 1/4 like the rest of the gearbox. However, it's a pretty high rpm, low torque motor, so I wouldn't expect it to be taking much force, plus it has thicker material surrounding it...
The banebots motor should be fine with this. If you were mounting a CIM on that, it would be an entirely different story....
Reply With Quote