Thread: Motor coupling
View Single Post
  #19   Spotlight this post!  
Unread 23-06-2002, 23:35
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
No Keyways for Chief Delphi...
Posted by Joe Johnson at 1/26/2001 9:59 AM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: We've made a custom shaft, not a coupling
Posted by Andy Baker on 1/26/2001 7:20 AM EST:



We have always managed to use either the double D's on the motors or the gears that are on the motors already or press on new gears/sprockets or used a trantorque type clamp on coupling.

We have yet to cut a keyway.

Haven't seen the need as of yet.

FYI.

Joe J.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.