Thread: Drill motor change out question??
View Single Post
  #8   Spotlight this post!  
Unread 23-06-2002, 23:36
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Drill motor change out question??
Posted by Matt Leese at 1/25/2001 10:18 AM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Rochester Institute of Technology.


In Reply to: Drill motor change out question??
Posted by Dennis Hughes on 1/25/2001 7:01 AM EST:



If there's a well designed drive train than the drill motors really shouldn't need to be changed. The only time drill motors start dieing is when too much load is put on them (either because of a bad gearing ratio or something like a side load). Then they can die rather quickly.

Matt
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.