Thread: U-bolts
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:43
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
U-bolts
Posted by Patrick Dingle at 1/27/2001 1:26 AM EST


Other on team #639, Red B^2, from Ithaca High School and Cornell University.



There was some brief discussion on the General Forum about using U-clamps/bolts to mount the drill motors to the robot. Let's say, hypothetically, that our team is using the drill motors, and hypothetically, we are considering clamping them on with large U-bolts. Does anyone have any wisdom about mounting motors with U-bolts? Or is it a bad idea in general?

Thanks
Patrick Dingle
Team 639 - Ithaca High School & Cornell University
prd8@cornell.edu


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.