Thread: Small Parts
View Single Post
  #6   Spotlight this post!  
Unread 23-06-2002, 23:44
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Brother, Can You Spare ... A Gear Shift Knob?
Posted by Dodd Stacy at 1/28/2001 9:34 PM EST


Engineer on team #95, Lebanon Robotics Team, from Lebanon High School and CRREL/CREARE.


In Reply to: What are you needing?... other teams may have spares
Posted by Andy Baker on 1/28/2001 9:20 AM EST:



: What do you need?

: Andy B.

Team 95 has misplaced, or perhaps did not receive, one of the drill gearbox shift selectors - the square of black plastic on top the housing that engages the bail, and your thumb pushes when you shift gears on a drill. I know almost everybody else throws away the drill housing and locks the box in gear - or makes a slick pneumatic shifter - but we're kind of partial to using the housing and the plastic "shift knob" and leaving it in one gear. We even retain the torque limiting clutch!

So, if anybody can spare this little junky piece of plastic, with the chrome hairpin spring on the back, please give me an e-mail and name your conditions. Thanks.

Dodd


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.