Thread: how do you hold pins in?
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 23:45
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
The Pins
Posted by Mark Garver at 1/27/2001 7:20 PM EST


Student on team #68, Truck Town Terror, from Waterford Kettering/OSMTech Academy and General Motors Truck Group.


In Reply to: Re: how do you hold pins in?
Posted by Ken Wilson on 1/27/2001 6:10 PM EST:



If I remember correctly, I believe the pins are 3mm x 15mm. If you can't find the 15mm you can use 16mm and they work fine.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.