Thread: how do you hold pins in?
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 23:45
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: how do you hold pins in?
Posted by nick237 at 1/27/2001 8:25 PM EST


Engineer on team #237, sie h2o bots, from Watertown high school ct and sieman co.


In Reply to: how do you hold pins in?
Posted by Brian on 1/27/2001 5:37 PM EST:



Brian. Do you have any toolmakers or machinests on your team, they would know how to retain a pin in a hole.
assuming you dont then you could use a hardened bolt with a lock nut on it if you have the room.
Drilling holes through a shaft tends to weaken the rod and braking of the shaft at the drill area is possible with the high pushing powers need for this years games.
A key way is the best way but must be done by a qualified person.
nick237 ( nothings impossible )( except picking your nose with your elbow


: We put some pins in and they don't stay in? We can't come up with ideas, but they aren't legal. Please help us.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.