Thread: Modeled Kit Parts
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:46
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
AutoCAD -> inventor
Posted by Ken Leung at 1/28/2001 1:31 AM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: Modeled Kit Parts
Posted by Paul on 1/28/2001 12:42 AM EST:



: Does anyone know of any good sites that have a lot of the kit parts modeled in inventor??

Not sure if you done this already, but Ed Spark's library have lots of 3d models of kit parts like motors and the wheel assembly... You can convert AutoCAD files into Inventor files. But if you are looking for the rest of kit parts, then I might try asking some friends if they have more (they too, like to model parts in Inventor).



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.