|
Careful...
Posted by control guy at 1/29/2001 8:45 AM EST
Student on team #250 from HVCC.
In Reply to: Cooling Drill Motors
Posted by Gary Bonner on 1/29/2001 12:45 AM EST:
Can't remember about the legality of this move, but if it is, just be careful you don't hit the permanent magnet in the motor housing. That could seriously mess up a motor.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|