Thread: Cooling Drill Motors
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 23:48
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
not a lot of metal to spare...
Posted by Joe Johnson at 1/29/2001 2:10 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: What the Rule Book Says...
Posted by Nate Smith on 1/29/2001 10:31 AM EST:



I would not recommend this idea.

There is surprisingly little metal to spare. Below the metal is magnet. If you remove the magnet you remove output.

Beyond this, it would be very difficult to keep the debri out of the brushes and such.

High risk, low payoff.

I wouldn't play at that table if I were you.

Joe J.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.