Thread: calculating necessary ratio/pitch
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:49
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
also...
Posted by bill whitley at 1/29/2001 5:59 PM EST


Student on team #70, Auto City Bandits, from Powers Catholic High School and Kettering University.


In Reply to: calculating necessary ratio/pitch
Posted by bill whitley on 1/29/2001 5:57 PM EST:



Also any opinions on whether or not this is a good idea would be greatly appreciated. Has anybody tried it? Any success? Any clue as to coding to allow a near 360 degree range of motion (out lead screw, then back in). Any help is much appreciated.

Bill
Team 70



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.