[Mark McLeod]

Connect directly to the device you are trying to reach with a regular straight-through ethernet cable.

Set your PC IP address to match the device. That'll be different IP's at different steps in the setup process. Your original PC IP address should work if the router or bridge hasn't been touched yet, or set your PC to 10.13.58.6 if you've gotten past the set that changes the router or bridge IP's to 10.13.58.x

Type these addresses into your web browse:
Bridge--
--http://192.168.1.250 with your default PC IP address
or
--http://10.13.58.1 with your PC set to 10.13.58.6

Router--
--http://192.168.1.1 with your default PC IP address
or
--http://10.13.58.4 with your PC set to 10.13.58.6

You can reset the router and the bridge with a paperclip in a small hole in the back labeled "Reset" to get them back to the default IP addresses.
It'll also reset the default user names and passwords in case something got mistyped. All the settings in the manual will have to be redone.



If all else fails bring the equipment to tomorrow's workshop.