Thread: motor high gear/low gear switch...
View Single Post
  #7   Spotlight this post!  
Unread 23-06-2002, 23:50
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
We're in.
Posted by Andy Baker at 2/1/2001 8:57 AM EST


Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.


In Reply to: Re: motor high gear/low gear switch...
Posted by geoff on 1/31/2001 10:11 PM EST:



We'll be switching the arm from high to low on the drill motor gearbox, just like we did in '99 and '00.

We only had one match that we couldn't switch it over to high gear in '00 (out of about 50), so I'd say that it was a success.

From the input I'm getting from other teams that are using our '00 design, there are many others out there.

Andy B.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.