Thread: cutting wheels
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 23:52
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Drill and a belt sander...
Posted by Joe Johnson at 1/30/2001 10:47 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: lathe?
Posted by Ken Leung on 1/30/2001 8:39 PM EST:



I am ashamed to admit it but I have actually made
wheels using a hand drill and a belt sander.

I chuck the wheel-wannabe up in a hand drill, make a
visit to the belt sander and have a whale of a time.

Hey...

It works.

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.