|
Nate says, yes we do...
Posted by Nate Smith at 1/31/2001 9:30 PM EST
Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.
In Reply to: ken..u said we had em?
Posted by Anton Abaya on 1/31/2001 9:37 AM EST:
: : : umm, what can we do to compensate for the lack of the wire that connects to the gyros... i've been wanting to play with those suckers...
: : Unless I am really blind, FIRST has never given us connetors for the gyros. you need to solder (gasp!) wires to the connector on the gyro.
: or maybe we're both blind (me and joe)
: -antonymous
Page B-2 of the robot section(Kit of Parts List)
Connector for yaw rate sensor - 3pin, 24AWG x 12" - Red Container, Loose
Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|