Thread: torque spec?
View Single Post
  #7   Spotlight this post!  
Unread 18-12-2008, 13:40
Teched3 Teched3 is offline
Hodge1
FRC #0175 (BuzzRobotics)
Team Role: Mentor
  
Join Date: Apr 2006
Rookie Year: 1996
Location: Connecticut
Posts: 319
Teched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud of
Re: torque spec?
Just to add to the discussion:

Judging from you photo, the bolts look like they are brass, which would have a much lower yield strength than steel. Contact the manufacturer, as you may be able to replace the broken terminal bolt/nut. However, I am only guessing, since I haven't seen or handled the component as yet.
__________________
Sweat the details
Why is there never enough time to do it right, but always enough time to do it again!
Even if you're on the right track, if you sit still, you'll get run over!!!