Thread: Connecting hub sprockets to shafts
View Single Post
  #16   Spotlight this post!  
Unread 24-06-2002, 00:04
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
11mm Fenners!!!!
Posted by Joe Johnson at 2/2/2001 10:27 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: How about a Trantorque !
Posted by Ed Sparks on 2/2/2001 10:15 PM EST:



Zoinks! Do I feel stupid. I just bought some 10 mm
Trantorques and paid a bit more that what they cost to
have a machinist open them up to 11 mm specifically for
the purposes of using them with the Van Door Motors.

We did this last year and it worked extremely well.

Now that I know where to get 11 mm out of the box, I am
all set.

Thanks.

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.