|
Re: No response from speed controllers
Quote:
Originally Posted by finman
after installing all the updates and putting the newest cRIO image on the cRIO, our test robot works perfectly. as soon as i download the default labview code, i get no response from the speed controllers. where should i look to fix this?
|
I had the exact same problem. The root cause it that the correct DIO is not assigned by default.
Open the "Drive Open 2 motor" VI on the left side of the motion loop. Switch to the block diagram and add the slot number of the DIO you are using to the two "Motor Open Jaguar" vi's, the default would be "Slot 4".
__________________
CalGames 2009 Autonomous Champion Award winner
Sacramento 2010 Creativity in Design winner, Sacramento 2010 Quarter finalist
2011 Sacramento Finalist, 2011 Madtown Engineering Inspiration Award.
2012 Sacramento Semi-Finals, 2012 Sacramento Innovation in Control Award, 2012 SVR Judges Award.
2012 CalGames Autonomous Challenge Award winner ($$$).
2014 2X Rockwell Automation: Innovation in Control Award (CVR and SAC). Curie Division Gracious Professionalism Award.
2014 Capital City Classic Winner AND Runner Up. Madtown Throwdown: Runner up.
2015 Innovation in Control Award, Sacramento.
2016 Chezy Champs Finalist, 2016 MTTD Finalist
|