Thread: ETH 1 Port on Driver Station
View Single Post
  #1   Spotlight this post!  
Unread 03-01-2009, 09:38
Will_Sica Will_Sica is offline
Registered User
FRC #0612
  
Join Date: Jan 2009
Location: VA
Posts: 3
Will_Sica is an unknown quantity at this point
ETH 1 Port on Driver Station
Has anyone had any complications with the ethernet ports on the Driver Station?

I was loading code, from Labview, to the robot. The laptop was connected to the Eth 1 port and the Eth 2 port connected to the bridge.
Labview quit at around 50% and displayed an error message "Peer has disabled communications. Please retry." (Not exact error message)

The LED on the DS next to ETH 1 went out after this point.

Further attempts to load code were met with "Can not locate the Real-Time client", even after switching to different cables and computers.

If anyone has any experience or advice, it would be greatly appreciated.
Reply With Quote