Quote:
Originally Posted by excel2474
Ok, that's kind of what I thought, but I'm not sure how to connect the wires to the gyro. Is there some type of technique?
|
<unsure if i'm stating the obvious>
The "technique" to which you would be referring is Soldering,
http://en.wikipedia.org/wiki/Soldering
</unsure>
I personally like the suggested method of soldering the male end of a pwm wire right to the board.
Alternately, you could just solder some wire to the boards, preferably with a strain relief and then connect it to the analog breakout board with a pwm connector.