View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:18
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: 1/4" chain and links from small parts

Posted by Matt Berube at 2/5/2001 2:35 PM EST


Engineer on team #49, Delphi Knights, from Buena Vista High School and Delphi Automotive.


In Reply to: 1/4" chain and links from small parts
Posted by Alan Federman on 2/5/2001 1:43 PM EST:



Yes, we had problems also.

It seemed to me that the holes in the top plate (?) were too small for it to fit over the pins.

I used our chain tool to press on a plate that I had removed from another link. It is working so far but that is because I haven't had to take it apart before.

Matt B.
T49
The Knights


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.