Thread: Re: Connecting hub sprockets to shafts
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:20
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Connecting hub sprockets to shafts
Posted by Patrick Dingle at 2/5/2001 11:36 PM EST


Other on team #639, Red B^2, from Ithaca High School and Cornell University.



Thanks to all who posted advice regarding connecting the sprockets to shafts. After some hard work trying to convince others on the team, we took the advice of Raul and Paul. We were able to machine a hole centered exactly tangential to the inner circumference of the hub... We even managed to cram a square peg (keystock) in a round hole! Anyway, it appears to work very nicely on our drive system and I see no possible way of breaking it.

Thanks again!

Patrick


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.