Thread: A little tip about those drill transmissions and bearings
View Single Post
  #5   Spotlight this post!  
Unread 24-06-2002, 00:22
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Thanks!
Posted by Jim Meyer at 2/7/2001 10:43 AM EST


Engineer on team #67, HOT Team, from Huron Valley Schools and GM Milford Proving Ground.


In Reply to: A little tip about those drill transmissions and bearings
Posted by Ed Sparks on 2/6/2001 6:42 PM EST:



Thanks for the tip Ed! I think we'll give it a try.

This is the sort of thing that makes these forums invaluable.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.