View Single Post
  #19   Spotlight this post!  
Unread 05-01-2009, 23:19
daltore's Avatar
daltore daltore is offline
Electronics/programming/design
AKA: Aaron Osmer
FRC #3529 (ausTIN CANs)
Team Role: Mentor
 
Join Date: Dec 2007
Rookie Year: 2007
Location: San Antonio, TX
Posts: 272
daltore has a spectacular aura aboutdaltore has a spectacular aura aboutdaltore has a spectacular aura about
Send a message via AIM to daltore Send a message via MSN to daltore Send a message via Yahoo to daltore
Re: Lunacy Wheels Static Electricity

Yeah, tonight we put a little pigtail wire on our robot because we ran out of people to "help" us move the robot that didn't know it would shock them (I know, I'm evil). Once we did that, you could barely hear a slight tick when you touch the frame, and you can't feel anything. A grounding brush eliminates most of the static electricity, but since there still is some, it's a potential worry. Static like this sits around a few thousand volts, and although it's very low current, it's enough to take out a single microchip. On our robot, everything is insulated from the frame except for the motors, which feed through the TB's. If you insulate the TB's, all of your electronics should be fine. However, I think the Jaguars' capacitors will take up the static if you happen to have something touching the frame. Just make sure more than ever that this year, YOUR FRAME IS NOT AT GROUND POTENTIAL. Last year, we had several wiring problems, and our frame was grounded, so every time someone got a little careless with a PWM cable and the +5 touched the frame, you got a pretty little fireworks show. This year, those pops could happen even without a short because of this static.

If they do not allow us to use grounding brushes (or even if they do, to lessen movement resistance), you might consider putting grounding brushes on the wheels themselves. It's the dielectrics that store charge (like the wheels and the floor), and the metal frame only conducts it. If you conduct it back into a closed circuit, it should eliminate the static electricity. I will test this tomorrow and report back its effectiveness. For right now, act as if this static electricity WILL damage your electronics and take the appropriate precautions. Just remember, nylon spacers are your friend!