Thread: Programming the second joystick in PBASIC
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:25
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
You are already done!
Posted by Eric Reed at 2/7/2001 3:57 PM EST


Coach on team #481, NASA Ames / De Anza High School, from De Anza High School and It could be you!.


In Reply to: Programming the second joystick in PBASIC
Posted by Will Korinek on 2/7/2001 8:40 AM EST:



: Hi just wondering how to go about getting the second joystick to make a pwm go up or down, and the trigger and thumb buttons work as relays.

: thanks,
: Will Korinek
: 646 Mechanical Animals


It's already there. Joystick one controls PWM1, Joystick 2 PWM2, etc. through 4. Similarly, the buttons are already programmed to the relays. I think the trigger on joystick one sends relay one forward, and the thumbswitch sends relay one reverse...but that might be backwards.

Good Luck,

Eric
Team 481


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.